DM500S is the smallest Linux satellite TV receiver with 1x Smartcard-Reader. It has excellent quality hardware and runs on open-source software. If you're looking for a VERY powerful and powerful unit, it is. It use for Sky and other Satellite broadcasters. You can connect up to 4 different LNBs to a 4-way switch&1 output to the receiver. It will understand each individual LNB signal and download all the channels for that satellite. It can card share in many ways including via IP, also record straight to your PC and so much more. It support Plug & Play ready for your FTA channels.   It is sold as an FTA receiver and .We will install the latest image.

• 250 MHz IBM PowerPC Processor (350 Mips)
• 2 LED status
• Linux Operating System
• Full automatic service scan
• Supports directly bouquet-lists (indirect unlimited)
• Supports multiple LNB-Switching control (supports DiSEqC)
• 1 x Smartcard-Reader
• Unlimited channel lists for TV/Radio
• SPDI/F interface for digital bit stream out (AC-3 / DTS)
• MPEG2 Hardware decoding
• Channel-change time < 1 second
• Fully adaptable OSD in many languages (skin-support)
• 100Mbit full duplex Ethernet Interface
• Supports EPG (electronic program guide)
• 1xScart-interfaces (fully controlled by software)

Tuner:

Frequency Range 950 .. 2150 MHz
Signal Level - 65 dBm .. - 25 dBm
Signal-to-Noise Level 12 dB max.
DBS-Tuner Input Connector F-Type female
Input Impedance 75 Ohm
AFC +/- 3 MHz
Demodulation Shaped QPSK
Input Symbol rate 2 .. 45 Mbaud/s, SCPC / MCPC
FEC Viterbi and Reed-Solomon
Viterbirate 1/2, 2/3, 3/4, 5/6, 7/8, automatic assimilation
Roll-off Factor 35 %
Demultiplexing according ISO 13818-1

Video decoder: Compression MPEG-2 & MPEG-1 / PAL & NTSC / Formats 4:3/16:9 / Footage 16:9, automatic assimilation for 16:9 TV-Device (over Scart) / Letterbox percolating for 4:3 TV-Device  

Audio decoder: Compression MPEG-1 & MPEG-2 Layer I&II / Mode Dual (main/sub), Stereo / Frequency: 32 kHz, 44.1 kHz, 48 kHz, 16 kHz, 22.05 kHz, 24 kHz 

Video parameter: Input FBAS 1Vss +/-0.3dB on 75 Ohm / Teletext filter with ETS300/472

TV-Scart: Output: FBAS,RGB,S-VHS over OSD selectable

Ethernet: 10&100 MB compatible, For update of update of Firmware & Reprogram

LNB Power and polarisation: 500mA max. ; short-circuit-proof / Voltage vertical&horizontal <14V&<20V without load, >11.5V&>17.3V at 400mA / LNB shut-off at Standby-Mode

Count of active satellite position: DiSEqC 1.0/1.2 Sat Position / Option  / DiSEqC - Rotor Control

Output digital:Output 0.5Vss on 75 Ohm / Sampled Data Filtering 32 kHz, 44.1 kHz, 48 kHz S/PDIF-Output optical (AC3)

Output analogue: Output L/R 0.5Vss on 600Ohm / THD>60dB(1kHz) /Crosstalk<-65dB

Serial Interface RS 232: 115 kb/s max /SUB-D-9 for update of Firmware & Reprogram

Power consumption: < 10W / 12V

Input voltage: DC12V,alternating acurrent +/- 15%

Extern power supply: Input:110-240V AC / 50-60Hz /0.6A   Output:12V/2A

Others: Ambient Temperature +15 - +35°C / Humidity < 80%